OPenpilot CC3D Revolution Board Setup. Introduction. Welcome to the Revolution ( Revo ) board setup page. Along with the tutorials you will also find links to the relevant Wiki pa OpenPilot Revolution. The Revolution is a full 10DoF flight controller board capable of stabilizing various aircrafts ranging from small racing miniquads to large FPV fixed wing models and aerial photography platforms. Along side standard stabilization modes it also supports various GPS assisted modes and GPS navigation flight. Connect ¶. Connect GPS to USB serial or USB. Start UCenter software. Select COM port used for GPS. Open console (F6 key) or View > Packet Console and check if link is correct, you should see messages output from GPS. If your board is correctly updated using the Rescue or Manual method but does not connect to the GCS, take a look at Bootloader version 4 is needed for CC3D/Atom or automatic reboot do not work correctly and Coptercontrol (CC) 4: bu_cc.opfw: CC3D: 4: bu_cc3d.opfw: OPLink Mini: 4: bu_oplinkmini.opfw: Revolution: 6: bu_revolution.opfw cc3d revolution setup 7 cc3d nano manual connectivity just like cc & cc3d, the revo has many ports, but a key new addition is the flexi- io port. pid tuning via autotune, easytune or manual by txpid different flightcontrollers : cc3d, revolution, sparky2, revo nano, and more! find many great new & used options and get the best deals for OpenPilot CC3D Revolution Flight Controller With OPLinK | Flying Tech flyingtech.co.uk. cc3d controller flight revolution openpilot schematic oplink manual io dimensions setup revo downloads tags flying radio kb flyingtech. Wholesale Price Cheapest Black White Cc3d Openpilot Multicopter Flight The OpenPilot Copter Control 3D aka CC3D is a board more tuned to Acrobatic flying or GPS based auto-piloting. It only has one sensor, the MPU6000 SPI based Accelerometer/Gyro. It also features a 16Mbit SPI based EEPROM chip. It has 6 ports labeled as inputs (one pin each) and 6 ports labeled as motor/servo outputs (3 pins each). The PWR Out pins provide unregulated voltage to the ports. If the CC3D is powered from a +15V (max. allowed) source then +15V will be on the PWR Out pins and can damage connected receivers, GPS, telemetry modems or other add-on boards. In case CC3D is powered through the servo connectors, then only connect the power from one ESC This is the first LibrePilot release. This version supports the CopterControl, CC3D, Atom, Revolution, Revolution Nano, Platinum GPS (V9) and OPLink Modems. The main focus of this release is to bring back support for CC3D and a general re-branding of the GCS. Some key addition in this release : Use LibrePilot instead. We've designed this section and the LibrePilot/OpenPilot Documentation as a whole to flow like a story, guiding you through all the steps necessary for successful setup and flight. New users will use this section to learn the basics of the system and progress to their first flight, while experienced users can refresh Others boards like Revolution support auto-configuration and no need this manual configuration using UCenter. This means also if you connect your 'CC3D GPS' to a Revolution board, your previous configuration is lost ! If GCS show "Coptercontrol" while board is connected and you really want to setup a GPS, this page is for you. Others boards like Revolution support auto-configuration and no need this manual configuration using UCenter. This means also if you connect your 'CC3D GPS' to a