Remove the four lower bolts that attach the lower bumper tabs to the vehicle (refer to attached photo). There are also another two self tapping screws in each NOTE: Prise the rear lip of the bumper off the retaining spigot where screw was located (as shown with arrow) then pull bar wing outward. 7. Remove front bumper Note: If fitting a winch proceed from here using fitting instructions 3789337 supplied with. 3500720 winch install kit. Once the winch is fitted please continue Tighten the bolts firmly – but allow enough movement for the bull bar to be adjusted. Page 14. Last Rev Date: 17/11/2009. Page 14 of 18. Fitting instructions#Remove bolts that hold the skid pan to the bumper bar. 6. Undo bolts from inside bumper assembly. 7. Remove recovery hook assemblies from bumper and unplug fog 1. Remove plastic bumper from the vehicle including all hardware located behind it. Note: Vehicle shown in Figure 1a is not fitted with Remove screws retaining bumper located under headlamp area. 12. Remove plugs securing upper bumper tabs. 13. If winch is to be fitted to bull bar, bend the.